7 8 concrete nails

7 8 concrete nails

...

7 8 concrete nails 7 8 concrete nails

Read More
  • Stainless

    7 8 concrete nails

    ...

    7 8 concrete nails 7 8 concrete nails

    Read More
  • 2, see if solder joint is firm, net width on both sides of whether level off, the wire have broken wire phenomena (note: net length is the length of the wire), welded wire mesh of the solder joint is normal after precise voltage debugging, welding of welded wire mesh with graphite, strong, and the net width on both sides of the cutting time is according to the broken wire knife to ensure smooth on both sides, There will be no leakage cutting on both sides of the protrusion of the wire is not cut off the phenomenon, the wire is broken, because the wire is not used up even if the column hole is blocked by the wire can not enter the normal cause, such as broken phenomenon can appear on the surface of the electric welding network lack of a wire.

    7 8 concrete nails

    ...

    7 8 concrete nails 7 8 concrete nails

    Read More

  • Post time: 10-02-23

    7 8 concrete nails

    ...

    7 8 concrete nails 7 8 concrete nails

    Read More
  • 1, stress relief before plating where the maximum tensile strength is greater than 1034Mpa key and important parts before plating should be at 200±10℃ stress relief for more than 1 hours, carburizing or surface quenching parts should be at 140±10℃ stress relief for more than 5 hours.

    7 8 concrete nails

    ...

    7 8 concrete nails 7 8 concrete nails

    Read More
  • 7 8 concrete nails

    ...

    7 8 concrete nails 7 8 concrete nails

    Read More
  • Galvanized

    7 8 concrete nails

    ...

    7 8 concrete nails 7 8 concrete nails

    Read More
  • 

    Popular articles

    Latest articles

    Links