punched metal sheets

Latest articles

punched metal sheets

...

punched metal sheets punched metal sheets

Read More
  • Three points should be selected before installation, which are the highest point (lowest) and the side line on both sides. The number of thorn rope column is good. When installing, it can be installed gradually according to the hook arrangement of thorn rope column.

    punched metal sheets

    ...

    punched metal sheets punched metal sheets

    Read More
  • In order to pack and bundle galvanized wire on the surface of the deposit layer to remove the surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless. Small homogeneous particles of large denier present in the tank can stabilize the foam layer. To remove surface active substances by matting with activated carbon. Or filtration to make the foam less stable, which are effective measures; Other measures should also be taken to reduce the intake of surfactant. The electroplating speed can be significantly reduced by the introduction of organic matter. Although the chemical formula is conducive to a high deposition rate, the coating thickness cannot meet the requirements after the organic matter is loaded, so activated carbon can be used to treat the tank.

    punched metal sheets

    ...

    punched metal sheets punched metal sheets

    Read More
  • 

    Popular articles

    Latest articles

    Links