weld mesh for concrete

1. Eliminate caked zinc residue on zinc liquid surface

Professionals tell us that the surface of high zinc barbed rope is not particularly smooth because of zinc, when holding the two products a comparison, you can find. Although the general zinc cord zinc layer thin but relatively smooth. Another way is to have a special instrument to measure, this kind of equipment is expensive, ordinary users can not buy the measurement. The last method is that there is a level gap in the sense of light, zinc thorn rope is bright and high zinc thorn rope brightness is slightly darker, so customers do not think that the appearance of the better product is good quality when buying.

For key and important parts with tensile strength greater than 1034Mpa, the stress should be removed at 200±10℃ for more than 1 hour before plating, and for carburized or surface hardened parts, the stress should be removed at 140±10℃ for more than 5 hours. The cleaning agent used for cleaning shall have no effect on the binding force of the coating and no corrosion on the substrate. Acid activation Acid activation solution should be able to remove corrosion products and oxide film (skin) on the surface of parts without excessive corrosion on the matrix.

When installing 250mm brick ties, it is important to follow the manufacturer's instructions and ensure proper alignment and spacing. Additionally, regular inspections and maintenance of the brick ties are essential to ensure their effectiveness and prevent any potential issues.