A. When the thickness of the plating is 3-4 mm, the zinc adhesion should be less than 460g/m, that is, the average thickness of the zinc layer is not less than 65 microns.

The mesh size of the wire mesh specification, as well as the diameter and thickness requirements, are limited to the amount of steel and galvanized per square meter. Mainly in order to consider the corrosion resistance, prolong the service life, and in the use of the process of safety.

2. When the weather is too dry and humid, remember to blow dry the cage or move it to a place with heating to prevent dry crack damage.

In the corner area, the zinc layer is often thicker than other places, and has good toughness and abrasion resistance. And other coatings in this corner, often Z thin Z is not easy to construction, Z is easy to hurt, so often need to be maintained. Even if there’s a lot of mechanical damage or something. Causing a small layer of zinc to peel off, leaving the iron base exposed, the surrounding zinc layer will act as a sacrificial anode to protect the steel from erosion.

Bed Sheet Set

However, the uniform structure of percale cotton also leaves it more prone to wrinkling. Meanwhile, sateen sheets practice a one-over-three-under weave to produce tightly knit, silky soft sheets. But over time, this smoothness may fade and be prone to snags. Percale and sateen weaves are top-notch options depending on your needs.

Microfibre

Upland