perforated plate stainless steel

First, the concept is different

The tensile strength of steel wire is high and the hardness is high. In the flattening process, the longitudinal movement resistance of steel wire per unit volume increases and the elongation decreases. The steel wire unit volume will move to the lateral resistance smaller, the width of the increase. On the contrary, the wire is easy to extend lengthwise, and its width decreases. This is the production of high steel wire hardness is easy to wide, small hardness, easy to stretch out of wide reasons. If the tensile strength deviation of steel wire is large, the hardness uniformity of steel wire strip is poor, the width difference of the billet rolled into large, will seriously affect the quality of the billet.

Cold galvanizing, also called electric galvanizing, is the use of electrolytic equipment to remove oil, pickling, after the pipe fitting into the composition of zinc salt solution, and connected to the negative electrode of the electrolytic equipment. Wire factory on the opposite side of the pipe fittings placed zinc plate, connected to the positive electrode of the electrolytic equipment is connected to the power supply, the use of current from the positive electrode to the negative electrode will deposit a layer of zinc on the pipe fittings, cold plating pipe fittings is first processed after galvanized.

If the seal is being fitted to original equipment you may have some influence over the shaft and housing bore finish, but if you are replacing a worn seal you still need to take into account the condition of these 2 essential parts.