pet kennel

Good galvanized wire, plating thickness of 3- 4 mm, zinc adhesion should be less than 460 grams/m, that is, the average thickness of zinc layer is not less than 65 microns. When the thickness of plated parts is greater than 4 mm, the zinc adhesion should not be less than 610 g/m, that is, the average thickness of zinc layer should not be less than 86 microns. Standard galvanized wire coating must be uniform, galvanized layer basically uniform with copper sulfate solution test etching five times no dew iron. For standard galvanized wire coating adhesion requirements, the zinc layer of plated parts should be firmly combined with the basic metal and have enough adhesion strength, after hammer test does not fall off, not convex.

One is to do a good job of galvanized wire packaging, avoid bump, to ensure the integrity of the zinc layer;

Take 20cm galvanized wire for acid fog experiment, check the zinc content of galvanized wire through the balance to see whether it meets the zinc layer standard required by the customer, ensure that the metal wire can achieve the role of rust and corrosion prevention, and meet the service life required by the customer. Galvanized iron wires must be packed in good condition, bound neatly and orderly, and bound with an inward end to prevent scratches during transportation. The inspection standard of galvanized iron wire also includes the tensile test. This item is determined according to the material of the galvanized wire order ordered by the customer, and it needs to be tested by comparing the raw material list.

Industrial rust prevention method: coated with asphalt, iron roof, coated with asphalt, you can prevent rust. Metal coating: Some metal surface will form a dense oxide film, can be coated on the surface of the metal composed of this metal screen. Such as: galvanized iron, tinplate plating, bicycle underwire and some medical equipment are coated with chromium and nickel.

Hongrispice Hot Chili Sauce