ring shank coil siding nails

Latest articles


  • No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.

  • Fourth, the difference between 201 and 304 is the problem of nickel. And the price of 304 is relatively expensive now, generally close to 20,000 yuan per ton, but 304 can at least ensure that it will not rust in the process of use. (Experiment with potions)

  • Latest articles

    Links