what size of drywall screws to use

It helps to dissipate heat. Building grid (floor heating) has good thermal conductivity and heat dissipation, the appearance of heat dissipation effect is more average 2 cm, 2.5 cm, 5 cm, 10 cm, 15 cm, 20 cm. Wire rope thickness, net length, net width, mesh and other indicators can be stopped at any time according to customer request. The mesh, solder joints, and mesh are all equal.

Most people think that the fine wire of the front and back twist barbed wire is not as thick and durable as common sense, but the front and back twist barbed wire is made of hot-dip galvanized steel wire, which is more than three times greater than the tensile strength of iron wire, and the amount of zinc added is not less than hot-dip wire

And high-quality data are constrained by production costs and production conditions, so some electric welding mesh manufacturers do not meet this requirement, in this case, there is no way to improve product strength. In addition to data, and produce process, even if again good data, but the factory did not meet the requirements of production process in welding, also can form the product under the high pressure welding, so it is also a kind of strength on the decline, process conditions of different manufacturers also have very big difference, so it formed a shopping mall on the above products are differences of strength.

The corrosion or discoloration of galvanized iron wire in the atmosphere caused by oxygen, moisture and other pollution impurities is called rust or rust. After galvanized iron wire rusting, it will affect the appearance quality, seriously affect the use, and even cause scrap, so galvanized iron wire must be properly kept and pay attention to rust prevention.

Galvanized hexagonal mesh uses: building wall fixed, heat preservation, heat insulation; Power plant piping, boiler heating; Anti-freezing, residential protection, landscaping protection; Raise chicken and duck, isolate chicken and duck house, play the role of protecting poultry; Protect and support seawalls, hillsides, roads and Bridges and other waterworks.

The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.