wire mesh manufacturers

wire mesh manufacturers

...

wire mesh manufacturers wire mesh manufacturers

Read More
  • Cold galvanized is in the plating tank through the current unidirectional zinc gradually plated on the metal surface, production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, poor corrosion resistance, generally a few months will rust. Compared with electrogalvanizing, hot galvanizing has lower production cost and less impact on the environment than electroplating.

    wire mesh manufacturers

    ...

    wire mesh manufacturers wire mesh manufacturers

    Read More
  • wire mesh manufacturers

    ...

    wire mesh manufacturers wire mesh manufacturers

    Read More

  • Post time: 22-11-22

    wire mesh manufacturers

    ...

    wire mesh manufacturers wire mesh manufacturers

    Read More
  • No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.

    wire mesh manufacturers

    ...

    wire mesh manufacturers wire mesh manufacturers

    Read More
  • 3. Salt water or alkali washing: In order to remove the residual acid in the dissolution tank, it is necessary to carry out salt water or alkali washing treatment on the steel wire to ensure that the surface of the steel wire is clean.

    wire mesh manufacturers

    ...

    wire mesh manufacturers wire mesh manufacturers

    Read More
  • 

    Popular articles

    Latest articles

    Links