barbedwire

barbedwire

...

barbedwire barbedwire

Read More

  • Post time: 11-11-22

    barbedwire

    ...

    barbedwire barbedwire

    Read More
  • In strict accordance with the multi-pass small compression rate drawing, the total compression rate is 96.48%, reducing the scraping of zinc layer. The whole wire drawing die is made of tungsten steel die and polycrystalline die. The Angle of the working cone of the wire drawing die is 12° ~ 16°, and the length of the sizing belt is 0.15 of the diameter of the wire, so as to ensure that the deformation of the zinc layer is basically synchronous with the steel wire substrate.

    barbedwire

    ...

    barbedwire barbedwire

    Read More
  • 3, twist the weight of hexagonal mesh production plant, the greater the weight, the more sufficient the material.

    barbedwire

    ...

    barbedwire barbedwire

    Read More
  • barbedwire

    ...

    barbedwire barbedwire

    Read More
  • ③ The galvanized iron wire shall not be damaged when it is tightened.

    barbedwire

    ...

    barbedwire barbedwire

    Read More

  • Post time: 15-02-23

    barbedwire

    ...

    barbedwire barbedwire

    Read More
  • When laying steel wire mesh, according to the laying method from the middle to both sides in turn. Wall plastering engineering use wire mesh material is generally two kinds: one is electroplating, the other is hot dip galvanized. The former has low cost and a wide range of use. The cost of hot-dip galvanized material is slightly higher than that of electroplating, and the cost is high and the life is good to prevent rust. Hot dip galvanizing is in the case of heating plating. After the zinc is melted into liquid form, the base metal is immersed in it so that the zinc interpenetrates with the base metal and binds so tightly that there are no other impurities or defects left in the process.

    barbedwire

    ...

    barbedwire barbedwire

    Read More
  • 

    Popular articles

    Latest articles

    Links