With the increasing use of hook mesh, the method of bridge rail is also different. The height of the outer railing of the walkway or seat belt should not be lower than 1.10 meters. The net distance between railings should not be greater than 140 mm and horizontal bar rails should not be used. The planning of the hook mesh is necessary to be safe and reliable, the bolt should be installed on the basis of the railing, its strength should meet the requirements of the standard.

Second, composition. Model 201 is composed of 17Cr-4.5Ni-6Mn-N, which is a substitute steel for type 301 steel. Anping wire rolling cage is magnetic after cold working, used in railway cars. 304 composition of 18Cr-9Ni, is the most widely used stainless steel, heat resistant steel. Used for food production equipment, Xitong chemical equipment, nuclear energy, etc.

After the appearance of barbed wire black spots, you can choose the appearance of treatment to deal with this problem, such as galvanized, spray painting, dip plastic to deal with, after the appearance of welding mesh appearance smooth and bright, beautiful and generous.

6, according to the wire diameter thickness to adjust zinc dipping time. Zinc dipping time should be adjusted according to the thickness of wire diameter. The method of adjustment is the length of the distance between the lead screw on the zinc pot and the ceramic sinking roll. The zinc dipping time of coarse wire diameter should be long, and the zinc dipping time of fine wire diameter should be short.

There are a variety of arc, non-divergence Angle and non-divergence height ladder types installed to provide ideal treatment plans. It can be used together with the appearance and the common design of the trackless active shift door, forming a harmonious and intact whole.

Cold galvanizing (galvanizing) is in the plating tank after the current unidirectional, so that the zinc gradually plated on the metal surface, slow production speed, uniform coating, thin thickness, usually as long as 3-15g, bright appearance, poor corrosion resistance, usually a few months will rust. Compared with hot dip galvanizing, the production cost of electric galvanizing is lower.

It’s important to consider the specific requirements of the application, including temperature range, mechanical stress, chemical exposure, electrical properties, and budget when selecting the most suitable carrier material for adhesive tapes. Each material has its advantages and is chosen based on the specific demands of the application.

As we’ve navigated through the intricacies of control boxes, it’s clear they are more than just containers; they are the nerve centers of any electrical system.