square weld mesh

Latest articles

square weld mesh

...

square weld mesh square weld mesh

Read More
  • square weld mesh

    ...

    square weld mesh square weld mesh

    Read More
  • Electro galvanizing shaft wire direct is in the electroplating tank through the current unidirectional zinc gradually plated on the metal surface, production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, poor corrosion resistance, generally a few months will rust. Compared with hot dip galvanizing, electric galvanizing has lower production cost. The difference between cold galvanizing and hot galvanizing: the difference between cold galvanizing and hot galvanizing is that the amount of zinc is different. They can be identified from the color. The color of cold galvanizing is shiny silver white with yellow. Hot dip galvanized shiny hair white.

    square weld mesh

    ...

    square weld mesh square weld mesh

    Read More
  • square weld mesh

    ...

    square weld mesh square weld mesh

    Read More
  • Wire factory introduction annealing wire is widely used mainly because it has good elasticity and flexibility, in the process of annealing can be very good control of its soft and hard degree, it is mainly made of iron wire, more often used in the construction industry tied wire use. In the production of annealing wire will be processed according to the performance of the material, according to the demand for different degree of hardness of its soft change, can make it has more advantages, can reduce the consumption of metal, reduce the cost of production.

    square weld mesh

    ...

    square weld mesh square weld mesh

    Read More
  • (4) Stop the use of more than two strands of galvanized iron wire around the operation method.

    square weld mesh

    ...

    square weld mesh square weld mesh

    Read More
  • Out-of-line annealing means that the recrystallization annealing of hot or cold rolled steel plate is carried out in the bottom type annealing furnace or cover type annealing furnace before entering the hot plating wire line, so that there is no annealing process in the galvanized line. The steel plate must maintain a clean active surface of pure iron, free of oxides and other dirt, before hot dip galvanizing. In this method, the annealed surface oxide sheet is first removed by pickling method, and then coated with a layer of zinc chloride or a mixture of ammonium chloride and zinc chloride solvent for protection, so as to prevent the plate from being oxidized again.

    square weld mesh

    ...

    square weld mesh square weld mesh

    Read More
  • 

    Popular articles

    Latest articles

    Links