diamond expanded metal mesh sizes

Requirements of the shaft
Even more important than a correct interference fit of the Oil Seal is a perfectly smooth shaft in the region of the seal, particularly if shaft surface speed is high and the medium to be sealed is under a certain amount of excess pressure. The surface roughness of the shaft depends on the average profile depth Ra of the tool marks caused by the machining process. Oil Seals made of PTFE require, independent of the surface speed, a surface roughness of between 0,1 to 0,2 mm, because PTFE has less wear resistance than rubber seals. For normal circumstances, the shaft in the region of the seal must have a surface roughness of approximately:  To summarize, the surface of the shaft in the region of the seal should not have noticeable machining marks. For pivoting shafts and other difficult or critical sealing applications, it is recommended that Oil Seals with a helical groove hydrodynamic pattern, which has a pumping effect, be used. When grinding and polishing, an axial movement of the grindstone along the shaft must be avoided in order to prevent machine lay. 

Finding the right rubber oil seal for your application

Advantages:
– Good static sealing
– Compensation of different thermal expansion
– Reduced risk of fretting corrosion
– Effective protection against air side contaminants
– Higher bore surface roughness is allowed
– Installation in split-housings
– Modern lip design provides low radial forces

Figure 9: Housing-bore eccentricity

AVAILABLE OIL SEAL STYLES & MATERIALS