micro perforated sheet

Latest articles

micro perforated sheet

...

micro perforated sheet micro perforated sheet

Read More
  • Our country industry chooses the low carbon steel with good quality as raw material, and then produces the quality galvanized iron wire by drawing, galvanizing and other processes. Now the production technology of galvanized iron wire products can be divided into hot plating and electroplating two kinds of methods. No matter which one is chosen, it should be carried out in accordance with the corresponding operating specifications, so as to better ensure the production of good products. For key and important parts with tensile strength greater than 1034mpa before plating, the stress should be released at 200±10℃ for more than 1 hour and 140±10℃ before plating.

    micro perforated sheet

    ...

    micro perforated sheet micro perforated sheet

    Read More
  • barbed

    micro perforated sheet

    ...

    micro perforated sheet micro perforated sheet

    Read More

  • Post time: 12-01-23

    micro perforated sheet

    ...

    micro perforated sheet micro perforated sheet

    Read More
  • ③ Galvanized iron wire shall not be damaged when it is tightened.

    micro perforated sheet

    ...

    micro perforated sheet micro perforated sheet

    Read More
  • Because of the corrosion resistance of zinc layer, can be applied to all kinds of environment, it is also very convenient to use, has been a more popular hardware products. Galvanized iron wire should pay special attention to the acyl wash, to slowly into the container, to prevent acid sputtering on the body, at the same time prohibit the water into, so it is easy to let the acid out, to learn to handle lightly, stacking should also be firm and neat. It can be widely used in construction, handicrafts and other daily civilian applications.

    micro perforated sheet

    ...

    micro perforated sheet micro perforated sheet

    Read More
  • During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.

    micro perforated sheet

    ...

    micro perforated sheet micro perforated sheet

    Read More
  • blade

    micro perforated sheet

    ...

    micro perforated sheet micro perforated sheet

    Read More
  • 

    Popular articles

    Latest articles

    Links