colored wire dog crates

Latest articles

colored wire dog crates

...

colored wire dog crates colored wire dog crates

Read More
  • 1, stress relief before plating where the maximum tensile strength is greater than 1034Mpa key and important parts before plating should be at 200±10℃ stress relief for more than 1 hours, carburizing or surface quenching parts should be at 140±10℃ stress relief for more than 5 hours.

    colored wire dog crates

    ...

    colored wire dog crates colored wire dog crates

    Read More
  • To remove surface active substances by matting with activated carbon. Or filtration to make the foam less stable, which are effective measures; Other measures should also be taken to reduce the amount of surface-active substances brought in to Z. The electroplating speed can be significantly reduced by the introduction of organic matter. Although the chemical formula is conducive to a high deposition rate, the coating thickness cannot meet the requirements after the organic matter is loaded, so activated carbon can be used to treat the tank.

    colored wire dog crates

    ...

    colored wire dog crates colored wire dog crates

    Read More
  • colored wire dog crates

    ...

    colored wire dog crates colored wire dog crates

    Read More
  • colored wire dog crates

    ...

    colored wire dog crates colored wire dog crates

    Read More
  • Through the maintenance of galvanized wire, it can not only greatly prolong its service life, but also improve its efficiency in the daily use process. Because the labeled electrode potential of zinc is -0.762v, which is negative than iron, zinc becomes the anode when the galvanic cell is formed after being corroded by the medium. It itself is dissolved to protect the steel matrix. The duration of the protection of galvanized wire layer has a great relationship with the thickness.

    colored wire dog crates

    ...

    colored wire dog crates colored wire dog crates

    Read More
  • Good galvanized wire, plating thickness of 3- 4 mm, zinc adhesion should be less than 460 grams/m, that is, the average thickness of zinc layer is not less than 65 microns. When the thickness of plated parts is greater than 4 mm, the zinc adhesion should not be less than 610 g/m, that is, the average thickness of zinc layer should not be less than 86 microns. Standard galvanized wire coating must be uniform, galvanized layer basically uniform with copper sulfate solution test etching five times no dew iron. For standard galvanized wire coating adhesion requirements, the zinc layer of plated parts should be firmly combined with the basic metal and have enough adhesion strength, after hammer test does not fall off, not convex.

    colored wire dog crates

    ...

    colored wire dog crates colored wire dog crates

    Read More
  • 

    Popular articles

    Latest articles

    Links