drywall screws popping out

Steel wire mesh is finished by fine welding of active welding equipment. The material can be divided into cold wire drawing, hot galvanizing, cold galvanizing, dip plastic and so on. To be used for bridge reinforcement, bridge deck pavement, building reinforcement and so on.

The coating of electrode plays a very important role in the welding process. If adopting the light of the coated electrode welding, is in the process of welding, oxygen and nitrogen in the air can invade the molten metal, the metal iron and beneficial elements carbon, silicon, manganese oxide and nitride oxide and nitride formation, and remain in the weld, weld slag or crack. And melt into the molten pool in the gas can make the weld produces a large number of pores, these factors can make the mechanical properties of the weld is greatly reduced, at the same time to make the weld brittle.

In view of this situation, many manufacturers are committed to ensuring the corrosion resistance of titanium and titanium alloy under the premise of increasing the hardness of titanium alloy, and surface carburizing is one of the typical processing technology means. Similar to the surface carburizing treatment of steel, the surface carburizing treatment of titanium alloy is to make the active carbon atoms, diffusion to the internal of titanium alloy, the formation of a certain thickness of higher carbon content of the carburizing layer, after quenching and tempering, so that the surface layer of the workpiece to obtain high carbon content of titanium alloy wire.

The small homogeneous particles with large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles will cause explosion. Coating with activated carbon to remove surfactant, or filtering to make the foam less stable, are effective measures. Other measures should also be taken to reduce the amount of surfactant brought in to Z. The speed of electroplating can be significantly reduced by the addition of organic matter. Although the chemical formulation is conducive to high deposition rate, but the organic matter with the coating thickness can not meet the requirements, so activated carbon can be used to treat the tank liquid.