ss barbed wire

The galvanized requirements of the parts to be plated: the surface of the parts to be plated should be smooth, and there is no dirt that cannot be removed by pickling method. Such as paint, grease, cement, asphalt and excessive rotten harmful substances; All welds of welded components shall be sealed without air; Pipe fittings and containers must have exhaust and zinc inlet holes; The workpiece should be finished welded steel pipe without thread, if any thread should be protected.

And for the external insulation system is used in the brick veneer, as for the role of first should also be anti fall off followed by anti cracking, so should choose the grid 10×10×0.6, these are some experience choice, grid conversion from the national regulations of steel mesh specifications, using steel level conversion. The index of wire mesh size, wire warp, square meter steel content, galvanized amount, etc., mainly consider the corrosion resistance of wire mesh and the safety of the system! Galvanized wire mesh is more critical than wire diameter, galvanized amount is very important, must be hot plating, welding after plating is better than plating after welding, as for wire diameter, comprehensive consideration of site construction and to meet the needs of safety, 0.6 ~ 0.7 is better.

Relatively speaking, the wire is relatively soft, suitable for binding. Disadvantages are low hardness, low tension, easy to stretch, not suitable for building materials. In different applicable environment, we should make a reasonable choice. So in the usual use of cold drawing wire and wire, according to their own needs to choose, although the length of the same, but the performance is not the same.