2 inch by 2 inch wire mesh

When using these two products, it is obvious that there is a gap between them. By pulling or bending the wire, it is often difficult to restore the original, for example, if the same place is repeatedly bent, it will be found that it has broken, and the cold drawing wire will not. Cold drawing wire compared with iron wire, its hardness, tensile resistance, bending ability is greatly enhanced, suitable for building materials.

1. After getting the bird cage, do not rush to use it. Clean the cage with a clean cloth or rubber. Then use fine yarn paper (do not use coarse sandpaper randomly), gently polish some parts that need to be polished again to improve the surface finish and trace, and pay attention to not damage the original bamboo green. After careful observation, use a razor blade to carefully clean the individual areas with small burrs.

Scope of use: Because the obtained coating is thicker, hot-dip galvanizing has very good protective function than electric galvanizing, so it is an important maintenance coating for iron and steel parts in strict working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transportation, shipbuilding and other occupations. In agriculture, such as pesticide irrigation, greenhouse and construction industry, such as water and gas transportation, wire casing, scaffolding, Bridges, highway guardrail and other aspects, have been widely used in these years.

The smaller the mesh of decorative hook mesh, the finer the demand wire, the larger the mesh, the thicker the demand wire. For example, the mesh aperture of 6.5cm requires an iron diameter of 3.5mm to 4mm. Then a fine welding will break, and then thick too heavy, workers can not bear.