4x4 wire panels

When using these two products, it is obvious that there is a gap between them. By pulling or bending the wire, it is often difficult to restore the original, for example, if the same place is repeatedly bent, it will be found that it has broken, and the cold drawing wire will not. Cold drawing wire compared with iron wire, its hardness, tensile resistance, bending ability is greatly enhanced, suitable for building materials.

The advantage of galvanized iron wire after annealing: after annealing increases the elongation of the iron wire. Makes the product softer and increases the range of application. After electric galvanizing hot dip galvanizing. Copper electroplating is widely used and screen production. Galvanized iron wire is a soft iron wire product processed by low carbon steel wire through cold drawing, heating, constant temperature, and even heat preservation. Generally, the quality of ordinary galvanized iron wire will be relatively soft, the softness is relatively balanced, and the color is consistent. It is mainly used in construction, mining, chemical industry and so on.

2, performance characteristics. Zinc coating is thick, fine crystallization, uniform and no pores, good corrosion resistance; Is pure, the zinc plating layer in acid, alkali corrosion slower, such as fog Eng effectively protect tight sand-fixation matrix, the galvanized layer formed after chromate passivation, color white, army green, beautiful and easy, have certain adornment sex, because the galvanized layer has good ductility, and therefore can be rushed, rolling, cold bending and forming and not damage the coating.

Plug tube gasket

The other way oil seals work is by stopping outboard materials that can damage the machine or contaminate its lubricant. The outboard materials that the oil seal will need to stop depend on the application. However, the most common kinds are dirt, moisture, and the particles produced during manufacturing.

This type of oil seal can withstand only low speed and friction. It is recommended in places where thick fluid or grease is to be sealed. This is not recommended for difficult applications.