Wire factory introduction annealing wire is widely used mainly because it has good elasticity and flexibility, in the process of annealing can be very good control of its soft and hard degree, it is mainly made of iron wire, more often used in the construction industry tied wire use. In the production of annealing wire will be processed according to the performance of the material, according to the demand for different degree of hardness of its soft change, can make it has more advantages, can reduce the consumption of metal, reduce the cost of production.

Spray powder mainly acrylic powder, polyester powder and so on. Dipping is a kind of plastic coating process, that is, the plastic coating on the matrix, generally metal, such as: daily use of clothes hangers, pliers handles, scissors on the rubber sleeve, various handrails, etc. Plastic immersion is to heat the metal to spray plastic powder evenly on the metal to form a plastic film, or heat immersion liquid into the metal to cool it and then plastic coating on the metal surface.

• SIM method to prevent the spring from falling off (integral molding of spring and rubber)

Storage and Handling

Leather is probably the oldest of the lip materials still in common use, but the move towards mass production methods has seen a massive increase in the development of synthetic rubbers which lend themselves to accurate and repeatable injection and compression moulding. Nitrile (NBR) is still by far the most common elastomer for “normal” use, whilst Viton® (FKM/FPM) is rapidly replacing Polyacrylate (ACM) and Silicone (VMQ) for high-temperature applications. Viton® also has high resistance to abrasion and chemical attack making it a preferred elastomer. Recent developments in the use of PTFE for Rotary shaft seals has caused widespread interest particularly for high-speed shaft rotation or poor lubrication applications.

A more comprehensive study of aeration by Dinzburg⁸ showed that even a minimal level of aeration of an aggressive European SF oil led to protection of a VDF/HFP/TFE compound, but to severe deterioration of an HNBR compound. He notes that aeration increases the severity of aging in oil for silicone and acrylic elastomers, while decreasing the severity for FKM elastomers.

Car Oil Seal Types and Applications

Depending on the application, premium lip materials may need to be used, such as Ethylene-acrylic (Varmac®). This material features good abrasion and dry running capabilities, higher heat capabilities than nitrile and polyacrylate, and better low-temperature performance than polyacrylate.

J: Additional code is added here as an identifier when two or more seals have exactly the same type codes and dimensional numbers.

These problems can be overcome through a better understanding of the types of sealing materials available, redefined selection procedures and the consistent application of sound replacement and maintenance practices.

Housing Stop Installation

Oil Seals