6ft chain link fence

Latest articles

6ft chain link fence

...

6ft chain link fence 6ft chain link fence

Read More
  • In the electroplating tank through the current unidirectional make zinc plating on the metal surface gradually, the production speed is slow, the coating is uniform, the thickness is thin, usually only 3-15 micron, the appearance is bright, smooth, beautiful, poor corrosion resistance, generally will rust in a few months. The production process of hot wire plating mainly includes: preparation of the original plate → pre-plating treatment → hot dip plating → post-plating treatment → finished product inspection, etc. According to custom often according to plating pretreatment method.

    6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • The application of electric welding mesh is more and more widely, the technology is gradually mature, electroplating rust prevention, plastic coated treatment, used for breeding, grille, plus the frame to make a fence, etc.

    6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • One is to do a good job of galvanized wire packaging, avoid bump, to ensure the integrity of the zinc layer;

    6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • 6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.

    6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • 6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • In the calculation process of 12*14 specifications of barbed rope, it can not be calculated according to the above calculation formula, because first of all, two specifications of raw materials are used, the thinner the wire diameter, the higher the processing cost. Generally speaking, a kilogram of 12*14 barbed rope can reach about 7.5 meters, and the ratio of warp wire to barbed rope cannot be calculated according to the traditional ratio of 7 to 3. The specific use of how much wire and silk need to go through a series of professional measurement but also increase the loss of raw materials and other factors to calculate. Thorn rope factory will also according to customer needs to calculate the reasonable amount of customer use.

    6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • 6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • 5, the concentration of plating aid can not be too high, which is a factor that can not be ignored to reduce zinc consumption. The concentration of plating aid should not be too high. The galvanized line must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution should be controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is arbitrarily added without the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.

    6ft chain link fence

    ...

    6ft chain link fence 6ft chain link fence

    Read More
  • 

    Popular articles

    Latest articles

    Links