powder coated perforated metal sheet

Most people think that the fine wire of the front and back twist barbed wire is not as thick and durable as common sense, but the front and back twist barbed wire is made of hot-dip galvanized steel wire, which is more than three times greater than the tensile strength of iron wire, and the amount of zinc added is not less than hot-dip wire

In addition, the corrosion resistance of hot-dip galvanized wire will also be affected by other factors. For example, in different environments, especially in some special chemical environments, such as acidic or alkaline environments, the corrosion resistance of hot-dip galvanized wire may be affected to a certain extent. At this time, it may be necessary to use other materials that are more resistant to corrosion to replace the hot-dip galvanized wire.

Because they are afraid of the rain, so there is no need to say more, and the surface of the packaging is more afraid of the sun, so it is not recommended to prevent the outdoor blade thorn rope will cause the woven bag to become ineffective, resulting in the internal blade thorn rope exposed to affect the later use.

The surface of alluvium before hot dip galvanizing of orchard special electric galvanized shaft wire can partially remove the surface film layer, surface impurity and other shortcomings according to the basic technology to find and solve; Excessive foam is caused by soap and soapable surface active substances such as human fat into the tank. A moderate rate of foam production would be fine. There are many fine homogeneous particles in the tank, can stabilize the foam layer, with activated carbon mat to remove surface active substances. Or make the bubble unstable according to overworry, these are all reasonable countermeasures; Other strategies should also be used to reduce the amount of surface-active substances introduced. The introduction of organic matter can make the electroplating process speed drop sharply. Although the secret recipe of organic chemistry is beneficial to the high accumulation rate, the thickness of the coating can not meet the requirements after the organic matter is brought in, so the activated carbon can be used to solve the tank.