1 inch x 1 inch welded wire

The thorn rope belongs to the weaving industry, so it is less affected by environmental protection. The thorn rope will not be discarded in the production process, and it belongs to the weaving industry, so the situation is less affected by environmental protection.

And for the external insulation system is used in the brick veneer, as for the role of first should also be anti fall off followed by anti cracking, so should choose the grid 10×10×0.6, these are some experience choice, grid conversion from the national regulations of steel mesh specifications, using steel level conversion. The index of wire mesh size, wire warp, square meter steel content, galvanized amount, etc., mainly consider the corrosion resistance of wire mesh and the safety of the system! Galvanized wire mesh is more critical than wire diameter, galvanized amount is very important, must be hot plating, welding after plating is better than plating after welding, as for wire diameter, comprehensive consideration of site construction and to meet the needs of safety, 0.6 ~ 0.7 is better.

5.Specifications: BTO-10, BTO-12, BTO-18, BTO-22, BTO-28, BTO-30, CBT-60, CBT-65

Common galvanized iron wire equipment is usually used in barbecue net, barbecue net generally requires to have a long service life, with galvanized iron wire equipment to wire a layer of zinc, barbecue net is not easy to be corroded.

The management system of the rinsing water after wire pickling should be discharged regularly and regularly, and the rinsing water should be kept clean and low acid value as far as possible. It is more appropriate to control the pH value of 3. The concentration of plating aid should not be too high. The hot plating wire must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is added without reference to the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.

Titanium dioxide (TiO₂) is by far the most suited white pigment to obtain whiteness and hiding power in coatings, inks and plastics. This is because it has an extremely high refractive index and it does not absorb visible light. TiO₂ is also readily available as particles with the right size (d ≈ 280 nm) and the right shape (more or less spherical) as well as with a variety of post-treatments.

However, the pigment is expensive, especially when the volume prices of systems are used. And, there always remains a need to develop a full-proof strategy to obtain the best results in terms of cost/performance ratio, scattering efficiency, dispersion… while using it in coating formulations. Are you searching for the same?

Explore the detailed knowledge of TiO₂ pigment, its scattering efficiency, optimization, selection, etc. to achieve the best possible white color strength and hiding power in your formulations.

Lithopone B301, Lithopone B311 powder is white powder, non-toxic, odorless, insoluble in water, no reaction with H2S and lye, release H2S gas when reacting with strong acids.

EINECS: 215-715-5

TiO₂ possesses different qualities depending on whether it is produced as a pigment or a nanomaterial. Both forms are tasteless, odourless and insoluble.