high tensile galvanized wire

Latest articles

high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 10:05 【high tensile galvanized wire】
Read More
Cleaning feathers, bird feathers like people’s clothes, need to wash frequently, hot summer weather, bath can put the bird cage soaking part of the water, hot water and cold water can be used in autumn and winter, after the temperature is appropriate to put the bird cage in the water, such a bath is conducive to the health of the bird.
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 09:51 【high tensile galvanized wire】
Read More
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 09:40 【high tensile galvanized wire】
Read More
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 09:24 【high tensile galvanized wire】
Read More
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 08:49 【high tensile galvanized wire】
Read More
Tolerance range: radial mesh deviation range is not more than ± 4%, zonal mesh deviation range is not more than ± 3%; Solder joint tensile strength exceeds the national standard.
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 08:41 【high tensile galvanized wire】
Read More
When the ground is undulating, the installation method of barbed rope also needs to be changed accordingly, because the installation of the original installation method will not play a protective effect.
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 08:13 【high tensile galvanized wire】
Read More
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 07:51 【high tensile galvanized wire】
Read More
Post time: 27-03-23
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 07:50 【high tensile galvanized wire】
Read More
Galvanized wire coating rough, passivation film is not bright, bath temperature is too high. If the cathode current density is too high, zinc content in the bath is too high or sodium hydroxide and DPE content is too low; Solid particles or excessive foreign metal impurities in the electroplating solution can cause such problems. Solution: If the coating of large galvanized wire is rough, there may be solid particles in the plating solution. If the roughness of the part is severe, the current density may be too high.
high tensile galvanized wire
...

high tensile galvanized wire2025-08-16 07:38 【high tensile galvanized wire】
Read More

1
2
3
4
5
6
7
8
9
10

Popular articles

Galvanized hexagonal mesh uses: building wall fixed, heat preservation, heat insulation; Power plant piping, boiler heating; Anti-freezing, residential protection, landscaping protection; Raise chicken and duck, isolate chicken and duck house, play the role of protecting poultry; Protect and support seawalls, hillsides, roads and Bridges and other waterworks.

(2) Greenhouse special electric galvanized shaft wire shall not be used for waist hoop compression reinforcement, usually not used for all binding.

The blade gill net has 3-7 buckles every 2 turns, and it is a circle card. After being opened, it forms a spiral shape. When stretching, you must take protective gloves to prevent scratches. When opening, only one side of the gill net needs to be fixed, and then the gill net needs to be opened in the opposite direction. Pay attention to the spacing of the holes should not be too large, otherwise it will affect the aesthetic effect. As long as the time to slowly return to the line, simple operation, convenient construction.

The common specifications of small hexagonal mesh in production are: the width is 1.22m, and the commonly used width is generally 1m. In terms of length, there are basically no restrictions on small hexagonal nets. 1-100 meters can be produced. The production wire diameter of small hexagonal mesh is generally No. 27 wire to No. 18 wire, and the aperture size is 0.95cm-5.08cm.

Latest articles

Secondly, galvanizing can increase the mechanical strength of the product. The wire drawing process is to draw metal materials to make their grains thinner, thereby improving the mechanical strength of the product. Galvanizing can form a layer of zinc on the surface of the product, and the zinc layer itself has a high hardness, which can provide additional support during the wire drawing process and prevent the metal material from tensile fracture during the wire drawing process. Therefore, galvanized products after wire drawing can increase their strength and stiffness, and improve their tensile strength and torsional resistance.

Links