1 1 4 coarse thread drywall screws
Latest articles
1 1 4 coarse thread drywall screws
...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More
1 1 4 coarse thread drywall screws
Post time: 28-07-22...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More1 1 4 coarse thread drywall screws
...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More5, do not pull the wire beyond the plastic limit.
1 1 4 coarse thread drywall screws...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More1 1 4 coarse thread drywall screws
...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read MoreThe management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.
1 1 4 coarse thread drywall screws...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More
1 1 4 coarse thread drywall screws
Post time: 17-11-22...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More1 1 4 coarse thread drywall screws
...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More
1 1 4 coarse thread drywall screwsIn strict accordance with the multi-pass small compression rate drawing, the total compression rate is 96.48%, reducing the scraping of zinc layer. The whole wire drawing die is made of tungsten steel die and polycrystalline die. The Angle of the working cone of the wire drawing die is 12° ~ 16°, and the length of the sizing belt is 0.15 of the diameter of the wire, so as to ensure that the deformation of the zinc layer is basically synchronous with the steel wire substrate.
...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More1 1 4 coarse thread drywall screws
...
1 1 4 coarse thread drywall screws 【1 1 4 coarse thread drywall screws】
Read More
Popular articles
The application of black iron wire in the process is mainly through the hot metal billet rolled into 6.5 mm wire rod, and then put it into the wire drawing device into a different diameter line, and then gradually reduce the aperture of the wire drawing disk, cooling and annealing, coating and other processes, made into a variety of different specifications of iron wire, this kind of iron wire and ordinary black iron wire compared, will be softer, Softness is also very uniform, color is consistent, widely used in the construction industry, mining, chemical industry, welding mesh, welding hanger, reprocessing industry.
The external environment has great influence on the preservation of galvanized wire mesh. In the rainy season, it is necessary to pay attention to the air humidity of the workshop, warehouse and other departments. It is recommended to use a humidifier. Usually, the moisture absorption of book paper is larger than that of powder paper, and the pH value is higher. Generally speaking, in the normal environment of storage wire, storage time of two years is not corroded wire phenomenon. However, it should be noted that in the process of handling the iron wire, it should be handled gently to avoid the position of the coiling coil, which will cause the smooth pulling of the wire and affect the production.
Latest articles
-
-
The wire diameter of raw materials used in different types of barbed rope is also very different, but in the production and processing process of barbed rope need to know the amount of use.
-
Post time: 24-04-22 -
-
Through the maintenance of galvanized wire, it can not only greatly prolong its service life, but also improve its efficiency in the daily use process. Because the labeled electrode potential of zinc is -0.762v, which is negative than iron, zinc becomes the anode when the galvanic cell is formed after being corroded by the medium. It itself is dissolved to protect the steel matrix. The duration of the protection of galvanized wire layer has a great relationship with the thickness.
-
3. The structure of the dog cage should be reasonable
At the begining of 2023, our company completed one FRP DN6m thickener tank, as a part of Thickener System, for our USA customer.
But this grating may only be ideal for some kinds of construction projects. So you will want to understand fiberglass grating and how FRP grating is often used.

flue gas desulfurization.
Now that you know what FRP grating is, you should learn about the fiberglass grating uses. There are many ways that this type of grating is used, making it a versatile material.

In addition to standard sizes, we also offer custom-sized gratings. In Indonesia, grating products have the most extensive variations in mesh sizes including 38×38, 50×50, rectangular mesh 100×25, rectangular mesh 152×38, mini mesh 20×20, micro mesh 13×13, and with variable heights ranging from H25, H30, H38, to 50. Available surface finishes include concave, anti-skid, chequer plate, and flat.
Product Overview
Marine: Used in marine environments such as marinas, docks, boat ramps, and piers due to its excellent resistance to saltwater and other marine elements. Different textures and grid configurations have been developed for specific marine applications.
