modelling wire mesh

modelling wire mesh

...

modelling wire mesh modelling wire mesh

Read More
  • No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.

    modelling wire mesh

    ...

    modelling wire mesh modelling wire mesh

    Read More
  • As we all know, the use of hexagonal net for protection can protect the natural environment while protecting the bridge, which can not only green the ecological environment, but also prevent soil erosion.

    modelling wire mesh

    ...

    modelling wire mesh modelling wire mesh

    Read More
  • Now the production of stainless steel blade barbed rope unless it is a specially customized model, under normal circumstances are the use of a knife length of 22mm mold production, that is, we usually say bto-22 type. It’s not necessarily the case that there are specifications from 11mm to 65mm. Unless the customer insists on customizing the required length, the barbed rope manufacturer produces bto-22 stainless steel blade barbed rope.

    modelling wire mesh

    ...

    modelling wire mesh modelling wire mesh

    Read More

  • Post time: 12-08-22

    modelling wire mesh

    ...

    modelling wire mesh modelling wire mesh

    Read More
  • razor

    modelling wire mesh

    ...

    modelling wire mesh modelling wire mesh

    Read More
  • 

    Popular articles

    Latest articles

    Links