welded wire roll

The wire after the first plating, its strength limit is also higher than the first plating, plated zinc and then made of wire not only toughness and high strength. There is a lower figure in the strength limit of galvanized iron wire because of the quality of zinc, because the strength of zinc technology is several times smaller than the wire itself. It is difficult to hot-dip galvanize drawn wires, and it is impossible for finer and very fine wires to be coated with the desired thickness of smooth zinc.

The quantity should be the same as the contract, cold drawing, carefully record the quantity of each specification and packing method. If there is a label, check whether the label is correct and take a photo to confirm. Each roll of iron wire is fastened with galvanized packing tape, and then tightly bound with a very strong transparent plastic bag. The outer layer of coated iron wire is wrapped with white braided cloth, and the outer layer of galvanized iron wire is wrapped with green braided cloth, so as to ensure that the packaging will not be lax in the transportation process. One end of the wire must be clearly marked and the other end left on the outer layer for easy connection by other wires.

When the large roll galvanized wire galvanizing process coating foaming, first check the bath temperature. If the bath temperature is not low, then strengthen the plating before removing oil, prevent the matrix metal in acid corrosion. If you pay attention to these problems, the foaming phenomenon still exists, it should pay attention to the amount and quality of additives, then you can stop adding additives, with high current electrolysis for a period of time, in order to reduce the content of additives, observe whether the foaming phenomenon is improved. If there is still no improvement, it is necessary to check whether the storage period of additives is too long, or whether there are too many impurities in the additives.