razor wire

Reverse twist: Twist the barbed wire in the opposite direction from where the nematocyst is wound around the main wire. It’s not twisted in one direction. It’s called the reverse twist.

If the solder joint is too deep, it is not good, although the welding is more solid, but the bearing capacity of the solder joint is greatly reduced, once the pressure exceeds the load range, it will fracture at the solder joint, so it is more dangerous to use. Large galvanized wire production process of low carbon steel wire cleaning cleaning agent, should have no effect on the binding force of the coating, no corrosion of low carbon steel wire. Production process, acid activation acid activation liquid, should be able to remove the surface of low carbon steel wire corrosion products, oxide film, no corrosion to the matrix.

The insulation layer of large rolls of galvanized wire and rigid thermal insulation products can be bound with double strands of galvanized iron wire, and the binding interval shall not exceed 400mm. The pipe or corresponding equipment with nominal diameter equal to or greater than 600mm shall stop reinforcement after binding, and the enclosed galvanized steel wire must be winched. The iron or wood rod should be tightened, but the tightening level should be moderate, not too tight or too loose, and not damage the wire. The consumption of wire and steel wire is generally used in drawing process and galvanized disposal.