aluminium perforated panel

Wire diameter: 0.6 (mm)

Hot dip galvanizing has been used for more than 150 years, and its principle has not changed so far. The steel structure should be fully immersed in zinc at one time to achieve uniform galvanized film structure. If it is too long or too wide to be dipped twice, the zinc layer at the joint will appear rough, too thick and so on. In addition, if the single weight of steel structure is too heavy, it will make its operation difficult if it exceeds the load of galvanizing equipment. Therefore, the communication with the hot dip galvanizing factory in advance.

3. The transport, storage and use of the binder of galvanized wire mesh should adopt safety and fire prevention methods according to the relevant regulations, so as to be safer.

Because the barbed rope is a strong use of regeneration value. Generally, the use of discarded guardrail networks for exercise, or steel production of new structural raw materials, do a good job of daily cleaning up and recovery can promote the value of the whole guardrail network faster. Again is to recover the use, the use of it in the appearance of the use of places that are not high, such as as other days purse Seine; Taking apart or discarding the raw materials that do not need to rust can carry out the whole regeneration.

The application of electric welding net is more widely, at present it has replaced the use of other parts of the wire mesh, the cost of electric welding net is lower, the production speed is very fast, so it is very popular. Welding net galvanized before the need for processing is recrystallization annealing, because the welding net must maintain a no oxide and no other impurities of pure iron active surface, if you can not keep its surface clean will lead to a bad galvanizing effect, galvanized layer and iron material is not closely combined, so this step is necessary.