perforated aluminium foil

Chemical Attack

To install an oil seal properly, the shaft must be undamaged. This is so the oil seal can do its job properly on the one hand, and to prevent it from being damaged during fitting on the other. In addition, it is very important to lubricate the shaft, the sealing lip and the bore with plenty of grease. This will allow the oil seal to slide more easily over the shaft and prevent dry running after the first rotation. The oil seal may also come into contact with the keyway, thread or other grooves when sliding over the shaft. By taping or covering the shaft at the location of these irregularities with oil-soaked paper, the oil seal can be mounted without damage to the sealing lip.

There is a British Standard laid down for the control of synthetic rubbers. BS 3574 (1989) helps to determine shelf life – for instance, Nitrile (NBR) and Polyacrylic (ACM) are Group ‘B’ rubbers and have a 7-year life, whilst Silicone (VMQ) and Fluoroelastomers (Viton®) are Group ‘C’ rubbers and have a 10-year shelf life. PTFE and Leather do not come into this category but like the others should be kept in the original packing for as long as possible away from direct light, dust, and humidity. Ozone, which can also be produced by battery-driven forklift trucks has a very bad effect on synthetic rubbers. Finally, protect the sealing lip – DO NOT hang the seals on nails, wire etc.

Which option is best? This decision is left entirely to you. Whatever solution you choose, the seal needs a proper fit to function.

Material used for Oil Seal :

The oil seal within the wheel hub assembly is crucial for preserving the lubrication of the wheel bearings and protecting them from premature wear and damage. Proper maintenance of the oil seal wheel hub is essential to prevent oil leakage and maintain the efficiency of the wheel assembly. Regular inspection and replacement of worn or damaged oil seals are vital to ensure the continued reliability and safety of the vehicle.

Oil seals have a flexible lip that actually rubs against the rotating shaft or housing to prevent leakage. The spring keeps the lip in contact with the shaft. Bearing isolator oil seals are dynamic seals that incorporate a rotor or rotating member and a stator or stationary member. The rotor actually turns with the shaft. Some oil shafts are bearing isolators with a labyrinth construction. Others incorporate simpler O-rings.

Leather is probably the oldest of the lip materials still in common use, but the move towards mass production methods has seen a massive increase in the development of synthetic rubbers which lend themselves to accurate and repeatable injection and compression moulding. Nitrile (NBR) is still by far the most common elastomer for “normal” use, whilst Viton® (FKM/FPM) is rapidly replacing Polyacrylate (ACM) and Silicone (VMQ) for high-temperature applications. Viton® also has high resistance to abrasion and chemical attack making it a preferred elastomer. Recent developments in the use of PTFE for Rotary shaft seals has caused widespread interest particularly for high-speed shaft rotation or poor lubrication applications.