steel perforated metal

Latest articles



Popular articles

  • The drawing process of the product drawing process has a great influence on the product function. Generally, a large total surface reduction rate of about 90% (see area reduction rate) and a small pass surface reduction rate (about less than 23%) are selected to ensure the endurance of the product. On the high strength spring steel wire, drawing should control the exit temperature of each passage of the steel wire is lower than 150℃, to avoid the steel wire due to strain aging and appear to change the crack, which is the formation of steel wire scrap the primary disadvantage.

  • During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.

  • galvanized

  • Latest articles

    Links