cheap welded wire mesh

In strict accordance with the multi-pass small compression rate drawing, the total compression rate is 96.48%, reducing the scraping of zinc layer. The whole wire drawing die is made of tungsten steel die and polycrystalline die. The Angle of the working cone of the wire drawing die is 12° ~ 16°, and the length of the sizing belt is 0.15 of the diameter of the wire, so as to ensure that the deformation of the zinc layer is basically synchronous with the steel wire substrate.

Compared with other galvanizing processes, galvanized steel wire has low cleaning requirements before plating. However, under the current trend of increasing the quality level of galvanized layer, some pollutants brought into the plating tank are obviously harmful. Because cleaning galvanized coating wastes a lot of time and reduces production, it is very important to properly clean and effectively rinse the substrate before electroplating.

Steel mesh manual binding line of the joint simple sliding, steel and concrete strength is weak, simple crack. The welded joint can accept not only pressure but also shear force. Longitudinal and transverse steel bars form a network structure, which plays a bonding anchorage effect. The number of solder joints per unit area is added when the diameter of the wire mesh is small and closely spaced. More conducive to strengthening the crack resistance of concrete, can reduce more than 75 percent of the attack of steel mesh cracks is a new, energy-efficient steel mesh structure, used in beams and columns, floors, roofs, walls, concrete pavement, bridge deck paving and other industrial and civil buildings.