iron fencing wire cost

Hot dip galvanizing is an effective metal preservative, mainly used in various industries of metal structure facilities. The steel parts after rust removal are immersed in the molten zinc solution at about 500℃, so that the surface of the steel member is attached with zinc layer, so as to play the purpose of anticorrosion. Hot dip zinc is to immerse the steel member after rust removal into the molten zinc liquid at about 600℃, so that the surface of the steel member is attached with zinc layer. The thickness of the zinc layer is not less than 65μm for the thin plate below 5mm, and not less than 86μm for the thick plate above 5mm. So as to play the purpose of corrosion prevention.

The wire after the first plating, its strength limit is also higher than the first plating, plated zinc and then made of wire not only toughness and high strength. There is a lower figure in the strength limit of galvanized iron wire because of the quality of zinc, because the strength of zinc technology is several times smaller than the wire itself. It is difficult to hot-dip galvanize drawn wires, and it is impossible for finer and very fine wires to be coated with the desired thickness of smooth zinc.

When laying steel wire mesh, according to the laying method from the middle to both sides in turn. Wall plastering engineering use wire mesh material is generally two kinds: one is electroplating, the other is hot dip galvanized. The former has low cost and a wide range of use. The cost of hot-dip galvanized material is slightly higher than that of electroplating, and the cost is high and the life is good to prevent rust. Hot dip galvanizing is in the case of heating plating. After the zinc is melted into liquid form, the base metal is immersed in it so that the zinc interpenetrates with the base metal and binds so tightly that there are no other impurities or defects left in the process.