galvanized crimped wire mesh

galvanized crimped wire mesh

...

galvanized crimped wire mesh galvanized crimped wire mesh

Read More
  • 5, the concentration of plating aid can not be too high, which is a factor that can not be ignored to reduce zinc consumption. The concentration of plating aid should not be too high. The galvanized line must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution should be controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is arbitrarily added without the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.

    galvanized crimped wire mesh

    ...

    galvanized crimped wire mesh galvanized crimped wire mesh

    Read More
  • galvanized crimped wire mesh

    ...

    galvanized crimped wire mesh galvanized crimped wire mesh

    Read More

  • Post time: 12-05-23

    galvanized crimped wire mesh

    ...

    galvanized crimped wire mesh galvanized crimped wire mesh

    Read More

  • Post time: 17-02-23

    galvanized crimped wire mesh

    ...

    galvanized crimped wire mesh galvanized crimped wire mesh

    Read More
  • The blade gill net of plastic paint is formed after rust protection processing after the manufacture of blade type barbed iron wire rope. The periphery of blade gill net should have good rust prevention effect, the peripheral processing should be beautiful, and can be of good practical value, more convenient installation, higher cost performance and other advantages. Plastic paint is a common electrostatic coating method, which can be fixed on the periphery of chicken wire or wire plate. After two hundred heat treatment, plastic paint or powder paint is glued to the surface of wire plate. These blade gill nets coated with plastic paint are generally used on indoor boxes. The coating processing does not take too long, mainly because the effect of rust prevention and corrosion protection is quite good, much better than the general material.

    galvanized crimped wire mesh

    ...

    galvanized crimped wire mesh galvanized crimped wire mesh

    Read More
  • During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.

    galvanized crimped wire mesh

    ...

    galvanized crimped wire mesh galvanized crimped wire mesh

    Read More
  • 

    Popular articles

    Latest articles

    Links