expanded steel mesh sheet

Latest articles



Popular articles

  • And the role of wire mesh in the exterior wall plastering if from an Angle to sail a method of anti-falling, the role of anti-cracking is relatively small, because of the problem of orientation; And about the external insulation system is used in the tile veneer, as for the role should also be anti falling followed by anti-cracking, so the grid should be selected 10×10×0.6, these are some experience selection, grid conversion from the national provisions of the wire mesh standard, choose the level of steel content conversion.
  • Good galvanized wire, plating thickness of 3- 4 mm, zinc adhesion should be less than 460 grams/m, that is, the average thickness of zinc layer is not less than 65 microns. When the thickness of plated parts is greater than 4 mm, the zinc adhesion should not be less than 610 g/m, that is, the average thickness of zinc layer should not be less than 86 microns. Standard galvanized wire coating must be uniform, galvanized layer basically uniform with copper sulfate solution test etching five times no dew iron. For standard galvanized wire coating adhesion requirements, the zinc layer of plated parts should be firmly combined with the basic metal and have enough adhesion strength, after hammer test does not fall off, not convex.

  • 1. Choose according to your dog’s size
  • Pressure welded steel grid plate is the steel grid plate fixed by pressure resistance welding at each intersection of bearing flat steel and transverse bar, which is called pressure welded steel grid plate. Torsion torsion square steel is generally used for cross bar of pressure welded steel grid. Although they do not belong to the same variety, but in the steel lattice plate standards and performance are still the same.

  • Latest articles

    Links