16d common

Latest articles

16d common

...

16d common 16d common

Read More
  • If the surface of galvanized wire hair black, galvanized layer is thin and uneven, this galvanized wire is partly because the inventory storage time is longer, it may also be because the production technical requirements of galvanized wire, do not meet the standard standards and lead to galvanized wire quality problems. According to the use of galvanized wire is different, galvanized wire has soft and hard, so the galvanized wire for binding requires the flexibility of galvanized wire is better, the flexibility of galvanized wire is good, which can facilitate the operation of workers.

    16d common

    ...

    16d common 16d common

    Read More
  • The smaller the mesh of decorative hook mesh, the finer the demand wire, the larger the mesh, the thicker the demand wire. For example, the mesh aperture of 6.5cm requires an iron diameter of 3.5mm to 4mm. Then a fine welding will break, and then thick too heavy, workers can not bear.

    16d common

    ...

    16d common 16d common

    Read More
  • 2, see if solder joint is firm, net width on both sides of whether level off, the wire have broken wire phenomena (note: net length is the length of the wire), welded wire mesh of the solder joint is normal after precise voltage debugging, welding of welded wire mesh with graphite, strong, and the net width on both sides of the cutting time is according to the broken wire knife to ensure smooth on both sides, There will be no leakage cutting on both sides of the protrusion of the wire is not cut off the phenomenon, the wire is broken, because the wire is not used up even if the column hole is blocked by the wire can not enter the normal cause, such as broken phenomenon can appear on the surface of the electric welding network lack of a wire.

    16d common

    ...

    16d common 16d common

    Read More
  • B. When the thickness of the plating is greater than 4 mm, the zinc adhesion should not be less than 610g/m, that is, the average thickness of the zinc layer should not be less than 86 microns.

    16d common

    ...

    16d common 16d common

    Read More
  • 16d common

    ...

    16d common 16d common

    Read More
  • 

    Popular articles

    Latest articles

    Links