steel mosquito mesh for windows

The cage door must be open so that the puppy can get out at any time. Once a puppy gets used to the crate, it will go in without your urging. Close the door for a few minutes when the puppy is having fun. But keep the crate in a busy area of your home, such as the kitchen. The puppy is relaxed and asleep in the safety of its cage. Cage trained puppies should not be caged for more than two hours during the day (unless you have to, but as soon as you get home from work let the puppy out). After getting used to the crate, the puppy is willing to stay in the playpen. Some dogs can’t stand the small space in a crate, but puppies are less likely to have this problem.

Regarding the placement of the cage, the top of the cage should not be higher than your standing eye level. This is because tall parrots are usually superior and not easy to tame. But for overly frightened parrots it can be slightly above your eye level. The bottom of the cage is usually equipped with a tray to prevent objects such as bird seed from falling to the ground and to prevent parrots from bumping their feet through the bars at night. The chassis should be covered with newspaper and replaced daily. To help the parrot feel safer, the cage should have a solid side and not be surrounded by bars. If a solid side is hard to find, put one side of the cage against a solid wall.

The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.

Packing is also very important. The cut wire should be bundled and tightly packed with plastic film, and then placed in a regular box. The whole box should be filled and sealed. It is better not to have half a box.