hex perforated sheet metal

The perfect solution to this is to always use an oil seal that fits properly; the right size of the seal should be used. And in other cases, backup devices should be used to avoid the buildup of clearance gaps within the mating edges.

OIL SEAL (LIP SEAL) VS. MECHANICAL SEAL: PROS & CONS OF EACH

EPDM oil seals are less common. They are used in solvent, hot water and steam applications, EPDM resists low temperatures down to -50 °C and UV radiation well. Some types of EPDM are also suitable for higher temperatures up to +150 °C. EPDM oil seals are usually available upon request.

Introduction

The seal shown in Fig. 14.2 is a relatively simple design; most automotive seals are more complex. Dust lips are often used to keep outside contaminants away from the oil lip seals; such seals thus have undercuts that make demolding more difficult. Fluoroelastomer compounds used for such undercut shapes must have reasonably high elongation at break at molding temperatures to avoid tearing the part during demolding. The metal insert is often U-shaped, and stock may be molded to form a thin layer over the outside of the insert. Since both compression and injection molding methods are used, suppliers of fluoroelastomers for shaft-seal applications often must provide different versions of the same polymer composition-medium to high viscosity for compression molding, and low to medium viscosity for injection molding. Different precompounds may be necessary to accommodate relatively long compression-molding times at low temperature and very short injection-molding times at high temperature.

Figure 3: Sealing function of main lip radial load
* KOYO is a registered trademark of JTEKT.

Figure 4 shows the features of a JTEKT oil seal.

-20 °C to + 130 °C

Automotive Gaskets: Diverse Applications and Materials

3. Garter Spring