powder coated expanded metal

Take 20cm galvanized wire for acid fog experiment, check the zinc content of galvanized wire through the balance to see whether it meets the zinc layer standard required by the customer, ensure that the metal wire can achieve the role of rust and corrosion prevention, and meet the service life required by the customer. Galvanized iron wires must be packed in good condition, bound neatly and orderly, and bound with an inward end to prevent scratches during transportation. The inspection standard of galvanized iron wire also includes the tensile test. This item is determined according to the material of the galvanized wire order ordered by the customer, and it needs to be tested by comparing the raw material list.

The quantity should be the same as the contract, cold drawing, carefully record the quantity of each specification and packing method. If there is a label, check whether the label is correct and take a photo to confirm. Each roll of iron wire is fastened with galvanized packing tape, and then tied with a very strong transparent plastic bag. The coated iron wire is wrapped with white braided cloth, and the galvanized iron wire is wrapped with green braided cloth, so as to ensure that the packaging will not be lax in the transportation process.

In strict accordance with the multi-pass small compression rate drawing, the total compression rate is 96.48%, reducing the scraping of zinc layer. The whole wire drawing die is made of tungsten steel die and polycrystalline die. The Angle of the working cone of the wire drawing die is 12° ~ 16°, and the length of the sizing belt is 0.15 of the diameter of the wire, so as to ensure that the deformation of the zinc layer is basically synchronous with the steel wire substrate.