metal fly mesh

Once you find that the beginning of it has deformation, rust or broken problems must be timely correction. Generally speaking, the blade barbed rope will not be damaged simply, but it cannot be ensured that it will not happen. Because the local place where the blade barbed rope is required is generally outdoors, the probability of presenting an incident will be greatly increased. For example, in the plantation under the hillside, the blade barbed rope was damaged and deformed by stones rolling down the mountain, which requires manual correction in time, otherwise the deformed blade barbed rope will not only affect the beauty, but also lay hidden dangers for safety.

The cleaning agent used for cleaning has no effect on the adhesion of the coating and no corrosion on the base material. Acid activation Acid activation solution should be able to remove corrosion products and oxide film from the surface of parts without excessive corrosion of the matrix. Zinc plating may be zinc plated with zincate or chloride and appropriate additives shall be used to obtain a coating that meets the requirements of this standard. After light plating, light treatment is carried out. Passivated parts requiring hydrogen removal shall be passivated after hydrogen removal. Activation with 1% H2SO4 or 1% hydrochloric acid for 5 ~ 15s prior to passivation.

There is in place to use, the blade thorn rope is commonly border, installation and use of the fence, and prisons, and galvanized barbed wire is in the orchard, fence livestock and so on the installation of large area, although the use of relatively large, but not as good as the use of blade thorn rope and high grade, so this is also the main reason for the price is quite high. Finally, the general installation site of the blade barbed rope for the protection level requirements are relatively high, so the quality requirements for the product is also relatively high, but the ordinary galvanized barbed rope because of the requirements in the installation site is more casual, which is also for the processing process for the quality requirements are relatively low.

The most obvious gap in a short period of time is the cross section of this piece, hot dip galvanized wire because it is surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.