4 foot chain link fence installation cost

For more severe oil-seal service at temperatures of 160°C (320°F) or higher for extended periods, more resistant fluoroelastomer compositions are required for long service life. High-fluorine VDF/PMVE/TFE elastomers, along with TFE/olefin FEPM elastomers, are much less susceptible to attack by oil additives. TFE/P fluoroelastomers have the requisite chemical resistance, but have low fluorine content, leading to relatively high swell and to soft vulcanizates with lower wear resistance than desired.

Oil seals applications 

The cover is fixed by nuts or bolts on top, or by screws round the edge. Loosen them all and remove them with their washers. If there are several oil-sealing washers under each fixing, note their order.

Leather is probably the oldest of the lip materials still in common use, but the move towards mass production methods has seen a massive increase in the development of synthetic rubbers which lend themselves to accurate and repeatable injection and compression moulding. Nitrile (NBR) is still by far the most common elastomer for “normal” use, whilst Viton® (FKM/FPM) is rapidly replacing Polyacrylate (ACM) and Silicone (VMQ) for high-temperature applications. Viton® also has high resistance to abrasion and chemical attack making it a preferred elastomer. Recent developments in the use of PTFE for Rotary shaft seals has caused widespread interest particularly for high-speed shaft rotation or poor lubrication applications.

Oil seal: get to know all the details about this component

In addition to these standardised types, the following special types are also available:

Heat resistance

②

Several variables must be considered when selecting oil seals. The physical dimensions and materials will vary depending on the environment of use. In addition, oil seals must remain lightweight, compact, and exhibit high self-lubrication performance.

ERIKS also supplies the types GR and GRST. These are virtually identical to the types R and RST, except in this case the metal inner ring is also completely encased in rubber. ERIKS uses FKM rubber here as standard, so these seals are ideal for use in acidic environments.