perforated plate ss 304

If the solder joint is too deep, it is not good, although the welding is more solid, but the bearing capacity of the solder joint is greatly reduced, once the pressure exceeds the load range, it will fracture at the solder joint, so it is more dangerous to use. Large galvanized wire production process of low carbon steel wire cleaning cleaning agent, should have no effect on the binding force of the coating, no corrosion of low carbon steel wire. Production process, acid activation acid activation liquid, should be able to remove the surface of low carbon steel wire corrosion products, oxide film, no corrosion to the matrix.

Origin: Hebei

The corrosion resistance of hot dip galvanized is much higher than that of cold dip galvanized, also known as electric dip galvanized. Hot wire will not rust for several years, cold galvanized will rust within three months. The cold galvanizing process is used to protect the metal from corrosion, for which the coating of zing filler is used,which is applied to the protected surface by any of the coating methods and dried to form a zinc filler coating with a zinc content (up to 95%) in THE DRY coating.

When using these two products, it is obvious that there is a gap between them. By pulling or bending the wire, it is often difficult to restore the original, for example, if the same place is repeatedly bent, it will be found that it has broken, and the cold drawing wire will not. Cold drawing wire compared with iron wire, its hardness, tensile resistance, bending ability is greatly enhanced, suitable for building materials.