Polyacrylate (ACM) Oil Seals

Conventional oil seals are the traditional seals, which can be recognised by a spring on the inside. These oil seals are made of a metal housing that contains a rubber seal. This part is often made of elastomer and comes into contact with the surface of the rotating shaft.

What is an Oil Seal?

Standard Sealing Lip Designs

• Low-friction torque design

ERIKS type R (type A according to the DIN standard) is identical in shape to type M, but has a rubber outer case with metal reinforcement on the inside. The rubber creates a good seal in the housing, even if the housing has suffered minor damage or is not in its best condition for other reasons. The RST version has a dust lip. These types are often chosen to replace a type with a metal outer case because they are easier to install and can cope with minor damage to the groove, such as scratches.

Tora Oil Seal:

Oil Seals – Everything You Need To Know About

a) The shaft on which the oil seal is to be mounted should be ground with the surface finish or surface roughness between 0.2 to 0.8 Microns. It is best for the shaft to be hardened atleast to 40 – 45 HRc in order to prevent groove formation on the shaft due to the pressure exerted by the spring.

Operating conditions such as the engine’s temperature, position, size, pressure and shaft speed largely determine which individual oil seal composition is most suitable for every individual application.

The dimensions of the 25x47x7 oil seal refer to its inner diameter, outer diameter, and thickness, respectively. These measurements are important in ensuring a proper fit for the seal in the machine or engine it is intended for. By providing a secure seal between moving parts, the oil seal helps to maintain proper lubrication in the machine and prevent the loss of oil.

Leather is probably the oldest of the lip materials still in common use, but the move towards mass production methods has seen a massive increase in the development of synthetic rubbers which lend themselves to accurate and repeatable injection and compression moulding. Nitrile (NBR) is still by far the most common elastomer for “normal” use, whilst Viton® (FKM/FPM) is rapidly replacing Polyacrylate (ACM) and Silicone (VMQ) for high-temperature applications. Viton® also has high resistance to abrasion and chemical attack making it a preferred elastomer. Recent developments in the use of PTFE for Rotary shaft seals has caused widespread interest particularly for high-speed shaft rotation or poor lubrication applications.