perforated sheet metal 4x8

Latest articles

perforated sheet metal 4x8

...

perforated sheet metal 4x8 perforated sheet metal 4x8

Read More
  • Out-of-line annealing means that the recrystallization annealing of hot or cold rolled steel plate is carried out in the bottom type annealing furnace or cover type annealing furnace before entering the hot plating wire line, so that there is no annealing process in the galvanized line. The steel plate must maintain a clean active surface of pure iron, free of oxides and other dirt, before hot dip galvanizing. In this method, the annealed surface oxide sheet is first removed by pickling method, and then coated with a layer of zinc chloride or a mixture of ammonium chloride and zinc chloride solvent for protection, so as to prevent the plate from being oxidized again.

    perforated sheet metal 4x8

    ...

    perforated sheet metal 4x8 perforated sheet metal 4x8

    Read More
  • 5, after the light plating should be carried out light treatment.

    perforated sheet metal 4x8

    ...

    perforated sheet metal 4x8 perforated sheet metal 4x8

    Read More

  • Post time: 17-05-23

    perforated sheet metal 4x8

    ...

    perforated sheet metal 4x8 perforated sheet metal 4x8

    Read More
  • In order to pack and bundle galvanized wire on the surface of the deposit layer to remove the surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless. Small homogeneous particles of large denier present in the tank can stabilize the foam layer. To remove surface active substances by matting with activated carbon. Or filtration to make the foam less stable, which are effective measures; Other measures should also be taken to reduce the intake of surfactant. The electroplating speed can be significantly reduced by the introduction of organic matter. Although the chemical formula is conducive to a high deposition rate, the coating thickness cannot meet the requirements after the organic matter is loaded, so activated carbon can be used to treat the tank.

    perforated sheet metal 4x8

    ...

    perforated sheet metal 4x8 perforated sheet metal 4x8

    Read More
  • 

    Popular articles

    Latest articles

    Links