collated fence screws

Next, apply a small amount of grease to the seal lip(s) and the area of the shaft in contact with the seal.  When using a double-lip seal, fill the small cavity between the two lips with grease as well. This both protects the lips during initial installation and break-in, and also acts as another barrier keeping contaminants out. When installing rubber-coated seals, apply lubricant to the outside diameter as well. This will help prevent the seal from rebounding or backing out from its mounting place.

After the oil seal has been installed, check for leaks. You can do this by applying pressure to the system and observing for any signs of a leak, such as fluid escaping from the area where the oil seal is installed. If a leak is present, you may need to remove the oil seal and start the installation process again.

VMQ (silicone)

5.  TYPES OF FLUID: Numerous oil seals can interact with oils, fuels, grease, water and more. However, know exactly what type of fluid the rotary shaft seal will be in contact with will ensure the longevity of the seal and the machinery.

Seals perform much better and longer when they are continuously lubricated with an oil that has the correct viscosity for the application and that is compatible with the seal lip elastomer material. The consideration of seal incompatibility, particularly with certain additives and some synthetic lubricants, should not be ignored, but unfortunately very often is.

Choosing the right oil seal

NBR, also known as nitrile rubber or nitrile, is the most popular material for an oil seal because of its good resistance to many oils and greases, such as mineral grease and hydraulic oil. Depending on their composition, synthetic oils and greases, such as those based on glycol, can damage NBR rubber materials. Depending on the amount of glycol, a PTFE lip seal may be the best choice. NBR is also unable to cope with contact with acids and solvents. The rubber is suitable for oil and grease at temperatures from -35 °C to 100 °C.

ERIKS type M (type B according to the DIN standard) has a single metal casing and rubber sealing lip. Since the casing is made of metal, it must be fitted in a well-finished, undamaged groove. Large volumes of oil seals with metal casings are often cheaper, which is why they are often used as original equipment in machines. However, if an oil seal has to be replaced, types with a rubber exterior (type R or RST) are easier to fit. Type MST is similar to M and commonly used. The difference is the dust lip in the MST oil seal that prevents dust and dirt reaching the sealing lip, and extends its service life in dusty environments.

PTFE

Early engines used O-rings (also called packing rings or toric joints) as seals (first patented in 1896). These are just mechanical gaskets in the shape of a torus (a circular ring--like a lifesaver), seated in a groove and compressed during assembly between two or more parts. It creates a seal at the interface. However, O-rings require a fluid film to lubricate them. They have limited usefulness in vacuum application and at extremes of temperature. The modern oil seal represents a significant improvement over the simple O-ring because it effectively seals in lubrication and prevents contamination from outside under a wide range of pressures and temperatures.

GVST

What are Oil Seals - Guide to what an Oil Seal is used for