what size screw for 1 2 sheetrock

Its specific design layout principle is:

2, see if solder joint is firm, net width on both sides of whether level off, the wire have broken wire phenomena (note: net length is the length of the wire), welded wire mesh of the solder joint is normal after precise voltage debugging, welding of welded wire mesh with graphite, strong, and the net width on both sides of the cutting time is according to the broken wire knife to ensure smooth on both sides, There will be no leakage cutting on both sides of the protrusion of the wire is not cut off the phenomenon, the wire is broken, because the wire is not used up even if the column hole is blocked by the wire can not enter the normal cause, such as broken phenomenon can appear on the surface of the electric welding network lack of a wire.

3, twist the weight of hexagonal mesh production plant, the greater the weight, the more sufficient the material.

Of course, the quality of any product is also affected by the implementation of the manufacturer’s norms. If it is the manufacturer of electric welding mesh in production, it does not have a high implementation of the norms, or the procedural norms on the production line have decreased, or there is no higher requirements on the production link.