crimped mesh

Latest articles

crimped mesh

...

crimped mesh crimped mesh

Read More
  • The difference is that hot dip galvanizing is dipped in zinc solution melted by heating, which has fast production speed and thick but uneven coating. The color is dark, the consumption of zinc metal is much, the formation of infiltration layer with the matrix metal, the corrosion resistance is good, and the outdoor environment of hot dip galvanized can be maintained for decades. Cold galvanized is in the plating tank through the current unidirectional zinc gradually plated on the metal surface, the production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, poor corrosion resistance, generally a few months will rust.

    crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • iron

    crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • Galvanized hexagonal mesh weaving process: double stranded hexagonal mesh, can be divided into three screws and five screws.

    crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • Now it is more used in the binding of the construction industry. Compared with ordinary iron wire, it is softer and has better luster. Use in daily life does not need to carry out maintenance and maintenance, save a lot of time, but also save the cost of maintenance and maintenance. Annealed wire has good stability, good corrosion resistance, greatly prolonging the service life. More kinds, can be selected according to different uses, making annealing wire device is simple, improve the utilization rate of the device. The material properties of annealed wire can meet different processing requirements.

    crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • In what aspects is the uniformity of galvanized wire reflected:

    crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • 1, stress relief before plating where the maximum tensile strength is greater than 1034Mpa key and important parts before plating should be at 200±10℃ stress relief for more than 1 hours, carburizing or surface quenching parts should be at 140±10℃ stress relief for more than 5 hours.

    crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • D, coating adhesion; The zinc layer of the plating parts should be firmly combined with the base metal with sufficient adhesion strength, and will not fall off or bulge after the hammer test.

    crimped mesh

    ...

    crimped mesh crimped mesh

    Read More
  • 

    Popular articles

    Latest articles

    Links