coil master nails

National standards on the use of wire mesh standards have certain requirements, diameter and mesh size matching use, rather than simply diameter, on the plaster layer to use the mesh should not be greater than 20×20, diameter is not easy to be less than 1mm, just choose diameter is not much meaning, choose 40×40×0.9 and choose 10×10×0.6 wire mesh, Which is better? I’m afraid it’s 10 by 10 by 0.6.

In this temperature range, the zinc solution is severely corroded to the workpiece and the zinc pot, and the iron is lost at 560 degrees Celsius to add obviously, and the zinc will be the iron substrate above 660 degrees Celsius, zinc slag will be added quickly, plating cannot be used. Therefore, electroplating is carried out in the range of 430~450 degrees Celsius.

There is a good toughness and elasticity, in short, it can be easily made into a variety of shapes, and zinc as a coating is silver, very beautiful. This feature makes hot-dip galvanized wire handicrafts, wire mesh and other aspects are also used. Hot plating wire selection of high quality low carbon steel wire rod processing, is the selection of high quality low carbon steel, after drawing forming, pickling rust removal, high temperature annealing, cooling and other processes.