wire crate

1) wire thickness: we also know that the pet cage wire is too thin to be easily bitten off by dogs, the general cage wire on the market are 3mm steel wire, such wire is only suitable for small dogs or rabbits, for large dog friends I suggest to buy more than 4mm thick.

When pickling, the galvanized wire needs to be slowly put into the cylinder to avoid liquid splashing on the body. Protective glasses should be worn in the pickling process to prevent acid splash out and hurt people. Pay attention to safety when receiving the line operation, the line tray needs to be lightly placed, stacked neatly, not more than 5 disks. No matter what kind of auxiliary materials are used, galvanized wire drawing must comply with national regulations, otherwise it is not allowed to be used.

Hot dip galvanizing is dipped in zinc liquid melted by heating, with fast production speed and thick but uneven coating. The market allows a low thickness of 45 microns and a high of more than 300 microns. The color is dark, the consumption of zinc metal is much, the formation of infiltration layer with the matrix metal, the corrosion resistance is good, and the outdoor environment of hot dip galvanized can be maintained for decades. Application range of hot dip galvanizing: because the coating is thicker, hot dip galvanizing has better protective performance than electric galvanizing, so it is an important protective coating for iron and steel parts in harsh working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, power transmission, shipbuilding and other industries, in the field of agriculture such as sprinkler irrigation, greenhouse and construction industry such as water and gas transmission, wire casing, scaffolding, Bridges, highway guardrail and other aspects, has been widely used.

No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.