custom perforated metal panels

Take 20cm galvanized wire for acid fog experiment, check the zinc content of galvanized wire through the balance to see whether it meets the zinc layer standard required by customers, ensure that the metal wire achieves the role of rust and corrosion prevention, and meet the service life required by customers. Galvanized iron wires must be packed in good condition, bound neatly and orderly, and bound inward to prevent scratches during transportation. The inspection standard of galvanized iron wire also includes the tensile test, which is decided according to the material of the galvanized wire order ordered by the customer, and it needs to be tested by comparing the raw material list.

Hot dip galvanized wire 5#-28#, including 500-1000 kg large plate hot dip galvanized wire. The hot dip galvanized wire we produce is made of national standard low carbon steel wire by drawing molding, pickling rust removal, high temperature annealing and other processes. The product has the characteristics of strong flexibility and good plasticity. The amount of zinc can reach 360 g /m2, which is welcomed by customers.

Steel mesh factory – improve the crack resistance and shock resistance of concrete. Because of the characteristics of steel mesh, it has good bonding and anchoring performance with concrete, and the load distribution is uniform, which greatly improves the seismic and crack resistance ability of reinforced concrete structure.

The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.

This process has no mold, low processing cost, easy forming, can process a variety of shapes and other characteristics are widely used. But the products of the guardrail are powder impregnated plastic. According to whether it needs heating, it is divided into hot dipping and cold dipping. According to the raw materials of dipping, it can be divided into liquid dipping and powder dipping. Hot-dip galvanizing, as a metal anticorrosion method, is usually to put the steel structure to be derusted into the zinc liquid at about 500℃, so that the zinc layer is attached to the surface of the steel structure.

Of course, the quality of any kind of product is also affected by the implementation of the specification by the manufacturer. If the manufacturer of electric welding mesh has no high implementation specification in the production itself, or the procedure specification has declined in the production line, or there is no higher requirement on the production link.